Privacy policy  |  Imprint  | 
Interior view of the warehouse of Beloh Magnetsysteme GmbH & Co. KG

Magnets and magnet systems


 

Sine tables with permanent magnetic chucks with simply pivoted about the longitudinal axis and double pivoted about the longitudinal and transverse axis, designed for grinding processes


-  with simply pivoted about the longitudinal axis

Currently not available!

Sine table with permanent magnetic chucks with simply pivoted about the longitudinal axisSine tables are particulary suitable for the precision grinding of workpieces with non-parallel surfaces. The angles can be set by means of slip gauges.

A sine chart is included in the delivery.

In order to avoid variations during the grinding operation, the table must be locked on the main spindle.

The sine tables are supplied with chucks with standard pole spacing or, if required, with fine pole spacing.

Technical features of the permanent magnetic chucks see here.

Features of the sine table:
- Low height
- Slip gauges can be set up to 45°; the table can be turned up to 90°
- The contact surface for gauge blocks lies on the 0 line and thus enables the setting
  of very small angles
- An angle can be set to within +/- 10 seconds of a degree.

Pole spacing: Steel 6 mm / brass 5 mm

Drawing sine table with permanent magnetic chucks with simply pivoted about the longitudinal axis

Further dimensions on request.

Machining of the top plate possible without impairing the holding power (steel 15 mm / brass 7 mm). Attechment of the sine tables to the machining table by means of clamping lugs. .
The chuck is fixed to the processing machine with clamping lugs.

Two end stops are supplied as standard.

Note: If necessary, the magnetic chucks can be fitted with an additional safety switch.


-  double pivoted about the longitudinal and transverse axis

Currently not available!

Sine table with permanent magnetic chucks with double pivoted about the longitudinal and transverse axis  Drawing sine table with permanent magnetic chucks with double pivoted about the longitudinal and transverse axis

Pole spacing: Steel 6 mm / brass 5 mm

Further dimensions on request.

Machining of the top plate possible without impairing the holding power (steel 15 mm / brass 7 mm). Attechment of the sine tables to the machining table by means of clamping lugs. The chuck is fixed to the processing machine with clamping lugs.

Two end stops are supplied as standard.

Technical features of the permanent magnetic chucks see here.

Note: If necessary, the magnetic chucks can be fitted with an additional safety switch.

You can prevent Google Analytics from collecting informations by clicking on the following link. An opt-out cookie will be set that prevents the future collection of your data when you visit this site: Disable Google Analytics OK